What are the applicable scope and precautions for anti-fatigue and anti-static mats?
Anti-fatigue and anti-static floor mats are suitable for production workshops and advanced laboratories of microelectronics industries such as electronic semiconductor devices, electronic computers, electronic communication equipment and integrated circuits. To reduce or eliminate the hazards of static electricity, it is necessary to lay anti-static table mats or conductive floor mats. , When the anti-static table mat (floor mat) is laid and grounded, the working surface will discharge the static electricity of the human body, so that the ESD tweezers, tools, appliances, instruments, etc. in contact between the human body and the table surface reach a basically uniform potential, so that the electrostatic sensitive devices ( SSD) is not interfered by the wide-step belt caused by electrostatic discharge phenomena such as friction electrification, so as to achieve the effect of electrostatic protection.
Precautions when using
1. The surface of the product is strictly prohibited from contacting acid and alkaline solvents (such as benzene, alcohol, etc.). This may cause the surface of the product to discolor, fade and decline in resistance. If cleaning is needed, wipe the cloth with a neutral solution (such as water, etc.).
2. The glue used should not only be compatible with the bottom of the pad product but also with the material of the workbench, it is not only firmly bonded, but also does not shrink after the product is stuck. It is recommended to carry out mass production after trial pasting.
3. Product shrinkage: The rubber content of the product is higher than that of the general table, the durability increases, and the tensile strength increases. It is recommended that the product specifications be lengthened and relaxed when cutting, and stored for 24 hours at the same time, so that the product has a fatigue recovery process. Carry out glue bonding production.